Scalar Pixie + PROWIN · Alignment Kit V2.1 · M4 AEG HPA

3D Printing Settings

• Estimated printing time: ~1 h 30 min, depending on the printer and settings.
• Filament: PLA+.
• Layer height: 0.10–0.15 mm.
• Infill: 65–80%.

Manuals

Installation and adjustment manuals are available in the Manuals section of the website or on the project's Discord server. Check the specific components and required screws for this variant before assembly.

Installation and Adjustment

1. Part Preparation
   Remove any printing residue and inspect the contact surfaces. If necessary, lightly and gradually sand the surfaces to improve the fit without forcing the parts together.

2. Assembly
   Position the Scalar Pixie engine and PROWIN hop-up chamber with the inner barrel in their designated mounting locations. Install the mounting components according to the manual for this specific variant.

3. Final Inspection
   Before connecting the air supply, verify that the nozzle is properly centered relative to the hop-up chamber and that there are no obstructions or interference within the assembly. Also, make sure the HPA line is not pinched when closing the replica.

Recommended Lowers

Using an ICS metal lower is recommended, provided it is compatible with this configuration.

If you prefer a 3D-printable lower, you can check the following designs:

• Gearbox V2 Lower "Universal Lower" — Version 3.
• Gearbox V2 Lower "Universal Lower" — Version 4.2.
• Gearbox V2 Lower "Universal Lower" — Version 4.3 MTW.

You can find them HERE.

Review the mounting requirements for each version before choosing one. This list does not automatically guarantee compatibility with the Scalar Pixie + PROWIN combination.